Clean water,
little effort.
Automatic ozone cycles and three-stage filtration keep the water clean between changes. Your part is a cover, a quick rinse of the pre-filter and a water change every few weeks.
What to do, and when.
Two schedules: one for a bath at home, one for daily commercial use.
Four steps.
- 01 01 · Switch off and drainSwitch off and unplug. Skim any debris from the surface, then remove the front drain fitting and unscrew the cap anticlockwise. Kyma drains through its own outlet in about 40 minutes, using the hose adaptor supplied.
- 02 02 · FilterRinse the pre-filter under a tap. Open the round access cover, loosen the vacuum relief screw, turn the filter housing anticlockwise and fit a new cartridge. Add water to the housing before you restart.
- 03 03 · RefillFrom a garden hose with clean water, to the operating level, 320 L, about 10–15 cm below the rim.
- 04 04 · Set the temperaturePlug in, switch on and set the temperature. Around 90 minutes to 2 °C from a typical fresh fill, with the cover on.
What Kyma does, and what you do.
Below freezing.
Kyma is IPX5 rated for terraces, gardens and outdoor spas. Keep it on a stable, level surface with the cover on between sessions.
In freezing conditions keep the water circulating and check the flow daily; if the air stays below 0 °C for 12 hours or more, drain the bath, filter and chiller. If Kyma will stand unused for a long period, drain it fully, open the red drain valves behind the rear panel, and store it dry and away from frost.
How often do I change the water?
Can Kyma go outside?
Do I need a plumber?
Ask us about Kyma, or see it in person in Barcelona.
Tell us where it is going and we will reply personally within one working day.